In terms of most models, the specific speed and speed matching are roughly as follows: the first gear corresponds to the engine at 2000-3000 rpm, and the speed is about 20-30 kilometers per hour;The second gear corresponds to the engine at 3000-4000 rh, and the speed is about 50-60 kilometers per hour.
What the poster is talking about may be the engine speed and speed handlebar of the motorcycle, that is to say, when the engine speed is 5000, the speedometer is 55 km/h. Instead of 50 km/h. If I understand correctly, it means that there is nothing wrong with your car. This is normal.
Take the common 125CC scooter as an example, when driving on a flat road, windless, light load and uniform speed, the engine speed is about 4500-5500 rpm/about, that is, about 5,000 rpm, which is not a very absolute speed, which will Driving conditions, vehicle conditions, road conditions, etc. vary and change.
1. Don't hurt the car, but often this It is also unbearable to run the engine at high load. The vehicle has passed strict inspection standards before leaving the factory. 5000 rvels is trivial, but you still have to cherish your own car.
2. The automatic transmission will cause certain damage to the engine at 5,000 rpm. In the starting state, the speed of the engine cannot be directly increased very high. In the starting state, the engine speed should be maintained between 2000-3000 rpm.
3. Is there a lot of automatic transmission 5000 conversion? Basically, it is not necessary, except for the time of vehicle inspection, because the vehicle will need to check whether the vehicle exhaust gas is qualified during the annual inspection. At this time, you need to step on the accelerator of the vehicle to the end, and the owner doesn't have to worry too much. It has no effect on the vehicle.
4. Automatic acceleration of 5000 will cause certain damage to the engine. In the starting state, the engine speed cannot be directly increased for 10 minutes. In the starting state, the engine speed must be maintained between 2,000 and 3,000 rm.After the car starts smoothly, the engine speed can be increased at this time.
5. The automatic transmission throttle 5000 turns does not hurt the car according to the actual situation. If the vehicle is in P gear and the engine of the car reaches 5,000 rPM, it will not hurt the car too much, but it will wear out the engine, but within a reasonable range.
6. In different gears, the speed of the vehicle reaches 5000 rpm, which has different impacts on the vehicle. The owner can refer to the following situations. If the vehicle is in P gear and the engine of the car reaches 5,000 rPM, it will not hurt the car too much, but it will wear out the engine, but within a reasonable range.
It depends on the displacement of the car.Generally speaking, the speed of a family car is 80 km/h, and the engine speed should be kept between 2000-2500 rm. For engines with a displacement of 4T, it is normal for the engine speed to be about 2000rpm, and the engine speed at idle can generally be maintained between 700rpm and 1000rpm.
This depends on the displacement of the car. Generally speaking, the speed of a family car is 80km/h, and the engine speed should be kept between 2000-2500 rpm.
This speed is not a big deal compared with this speed. It's normal. You should know that SUVs are generally not high-speed, and 3000 to 110 is reasonable. If it is confirmed that the same car is faster than yours at 2000 revs, it is also because he changed the tire or the clutch of your car slipped. This is the hard connection transmission ratio, which has nothing to do with carbon accumulation.
Hello, the speed of 80 miles and the speed of 5000 indicates that the clutch has slipped. I hope my answer can help you! [ If there is a problem with the car, ask the car master. 4S store professional technician, 10 minutes to solve.
Hello, it's not normal. Generally, the 5th gear runs 80, and the normal speed of the engine is about 2000 to 2200. The lower the speed, the better the engine. I hope I can help you.
It is normal to have a speed of 80 and a speed of 2000. For family cars, when the driving speed of the car is maintained at 80km/h, the engine speed will not exceed 2500 rm. For example, in a 6L automatic transmission car, the engine speed will basically remain below 2,500 rm.
HS code-driven CSR checks-APP, download it now, new users will receive a novice gift pack.
In terms of most models, the specific speed and speed matching are roughly as follows: the first gear corresponds to the engine at 2000-3000 rpm, and the speed is about 20-30 kilometers per hour;The second gear corresponds to the engine at 3000-4000 rh, and the speed is about 50-60 kilometers per hour.
What the poster is talking about may be the engine speed and speed handlebar of the motorcycle, that is to say, when the engine speed is 5000, the speedometer is 55 km/h. Instead of 50 km/h. If I understand correctly, it means that there is nothing wrong with your car. This is normal.
Take the common 125CC scooter as an example, when driving on a flat road, windless, light load and uniform speed, the engine speed is about 4500-5500 rpm/about, that is, about 5,000 rpm, which is not a very absolute speed, which will Driving conditions, vehicle conditions, road conditions, etc. vary and change.
1. Don't hurt the car, but often this It is also unbearable to run the engine at high load. The vehicle has passed strict inspection standards before leaving the factory. 5000 rvels is trivial, but you still have to cherish your own car.
2. The automatic transmission will cause certain damage to the engine at 5,000 rpm. In the starting state, the speed of the engine cannot be directly increased very high. In the starting state, the engine speed should be maintained between 2000-3000 rpm.
3. Is there a lot of automatic transmission 5000 conversion? Basically, it is not necessary, except for the time of vehicle inspection, because the vehicle will need to check whether the vehicle exhaust gas is qualified during the annual inspection. At this time, you need to step on the accelerator of the vehicle to the end, and the owner doesn't have to worry too much. It has no effect on the vehicle.
4. Automatic acceleration of 5000 will cause certain damage to the engine. In the starting state, the engine speed cannot be directly increased for 10 minutes. In the starting state, the engine speed must be maintained between 2,000 and 3,000 rm.After the car starts smoothly, the engine speed can be increased at this time.
5. The automatic transmission throttle 5000 turns does not hurt the car according to the actual situation. If the vehicle is in P gear and the engine of the car reaches 5,000 rPM, it will not hurt the car too much, but it will wear out the engine, but within a reasonable range.
6. In different gears, the speed of the vehicle reaches 5000 rpm, which has different impacts on the vehicle. The owner can refer to the following situations. If the vehicle is in P gear and the engine of the car reaches 5,000 rPM, it will not hurt the car too much, but it will wear out the engine, but within a reasonable range.
It depends on the displacement of the car.Generally speaking, the speed of a family car is 80 km/h, and the engine speed should be kept between 2000-2500 rm. For engines with a displacement of 4T, it is normal for the engine speed to be about 2000rpm, and the engine speed at idle can generally be maintained between 700rpm and 1000rpm.
This depends on the displacement of the car. Generally speaking, the speed of a family car is 80km/h, and the engine speed should be kept between 2000-2500 rpm.
This speed is not a big deal compared with this speed. It's normal. You should know that SUVs are generally not high-speed, and 3000 to 110 is reasonable. If it is confirmed that the same car is faster than yours at 2000 revs, it is also because he changed the tire or the clutch of your car slipped. This is the hard connection transmission ratio, which has nothing to do with carbon accumulation.
Hello, the speed of 80 miles and the speed of 5000 indicates that the clutch has slipped. I hope my answer can help you! [ If there is a problem with the car, ask the car master. 4S store professional technician, 10 minutes to solve.
Hello, it's not normal. Generally, the 5th gear runs 80, and the normal speed of the engine is about 2000 to 2200. The lower the speed, the better the engine. I hope I can help you.
It is normal to have a speed of 80 and a speed of 2000. For family cars, when the driving speed of the car is maintained at 80km/h, the engine speed will not exceed 2500 rm. For example, in a 6L automatic transmission car, the engine speed will basically remain below 2,500 rm.
How to build a trade data strategy
author: 2024-12-23 22:37Global trade data for currency hedging
author: 2024-12-23 22:18Real-time supplier performance scoring
author: 2024-12-23 22:01Trade data for government agencies
author: 2024-12-23 20:50HS code-driven sectoral analysis
author: 2024-12-23 20:46End-to-end shipment management
author: 2024-12-23 22:34Global trade finance benchmarking
author: 2024-12-23 21:57HS code-based customs dispute resolution
author: 2024-12-23 21:00HS code intelligence for oil and gas industry
author: 2024-12-23 20:49How to track compliance breaches
author: 2024-12-23 20:34335.74MB
Check116.33MB
Check794.46MB
Check227.85MB
Check855.86MB
Check937.86MB
Check545.29MB
Check779.86MB
Check743.69MB
Check758.19MB
Check534.84MB
Check688.37MB
Check319.97MB
Check161.87MB
Check237.45MB
Check941.24MB
Check982.53MB
Check518.76MB
Check722.91MB
Check427.39MB
Check646.94MB
Check595.54MB
Check771.91MB
Check576.47MB
Check851.51MB
Check564.44MB
Check781.76MB
Check279.27MB
Check413.39MB
Check512.53MB
Check886.12MB
Check684.48MB
Check361.72MB
Check367.81MB
Check989.26MB
Check774.31MB
CheckScan to install
HS code-driven CSR checks to discover more
Netizen comments More
2067 Trade analytics for risk mitigation
2024-12-23 22:46 recommend
744 HS code harmonization in NAFTA region
2024-12-23 21:52 recommend
1178 Agriculture trade by HS code in Africa
2024-12-23 21:33 recommend
2947 Industrial lubricants HS code classification
2024-12-23 20:48 recommend
387 HS code reference for mineral exports
2024-12-23 20:42 recommend